ARIETE 2878 Mode D'emploi page 14

Instead to warm slightly frothed milk or froth smaller amount, use the insert
without spiral.
1. Remove the lid of the container.
2. Insert the appropriate insert into the sleeve at the bottom of the container.
3. Pour the milk to the maximum level, shown by the dash at the MAX mark:
MAX for the insert with spiral.
MAX for the insert without spiral.
4. Place the lid firmly on the container.
Froth and heat the milk
During the first heating a slight odour may develop, which is not dangerous. Provide adequa-
te ventilation.
• Shortly press the ON/OFF button.
The operation indicator light switches on in red.
The appliance starts heating and frothing the milk.
When ...
... the insert with spiral is used, the frothing process will have a duration of about 1.5 minutes,
... the insert without spiral, the frothing process will have a duration of about 2 minutes.
The heating and frothing process then stops automatically.
Then remove it is possible to remove the container from the base.
Froth the milk cold
It is also possible to froth the milk without heating it. To obtain a soft and creamy froth use only
the insert with spiral.
• Press the ON/OFF switch and hold down for about 2 seconds, until the appliance starts
to froth milk.
The indicator light switches on in blue. The appliance starts to froth milk. After about 1 to 1.5
minutes, the milk frothing process stops automatically. Then remove it is possible to remove
the container from the base.
Stop or finishing the milk heating and frothing in advance
• Press the ON/OFF switch.
14
To avoid losing it, keep the insert that is not used in the
compartment located at the bottom of the base.
Warning – material damage
Respect the MIN and MAX marks inside the container. The
sleeve in the bottom of the container must be covered by
milk. In case of insufficient amount of milk, the appliance
may overheat. In case of excessive amount, milk can instead
overflow.