tomado TPM1502S Mode D'emploi page 15

Check that the voltage stated on the information plate matches the voltage used in your region. Place the coffee machine on a
flat, stable and heat-resistant surface. Insert the plug in an earthed wall socket.
1. Take the removable water reservoir from the appliance, slide the cover upwards and fold it over.
Fill the water reservoir with cold drinking water. Do not fill it above the MAX mark. Place the cover back on
the reservoir and slide the reservoir back into the appliance.
2. Take the filter holder from the appliance by turning it clockwise.
3. Fill the one- or two-cup filter with the required amount of coffee by means of the provided measuring
spoon. Firmly compress the coffee using the tamper. Depending on your taste, approximately 1 cup of
coffee can be made with 1 measuring spoon. When using coffee capsules for making coffee, you can place the capsules of
your taste in the filter provided for that purpose. Attention! Avoid making contact with the blades in the filter for coffee
capsules, these are very sharp.
4. Place the filter in the filter holder, making sure that the ball at the side of the filter falls precisely into the indentation in the
holder. Then place the holder in the appliance from position
.
5. Place the required number of coffee cups on the cup grille. Make sure the cups are properly positioned, so that the coffee
flows into the cups.
6. Check that the steam controller is switched off (turned upwards). Switch on the appliance by pressing the on/off button,
after which the indicator light switches on. The indicator light next to the coffee button is flashing to indicate that the
appliance is being pre-heated. When this light remains on, press the coffee button and the coffee will start to flow. Press the
coffee button once more when the required amount of coffee has been made. If you do not do this, the cup will overflow!
Attention: After making coffee, the indicator light may start to flash again to indicate that the appliance is pre-heating. When
the light remains on, you can continue making coffee.
7. Coffee tastes best immediately after it has been made, so do not wait too long before serving.
Tips:
• We recommend slightly warming up an espresso cup prior to use, for instance by first placing it on the hot plate on top of
the appliance. A pre-heated cup will prevent the espresso from cooling down too quickly.
• In order to make a good espresso, we recommend pre-heating the appliance. This is done by first making a cup of espresso
without adding coffee, as a result of which hot water flows through the appliance.
Warning: Do not leave your coffee machine unsupervised when it is working, because of the manual actions you have to
perform.
Check that the voltage stated on the information plate matches the voltage used in your region. Place the coffee machine on a
flat, stable and heat-resistant surface. Insert the plug in an earthed wall socket.
1. Take the removable water reservoir from the appliance, slide the cover upwards and fold it over.
Fill the water reservoir with cold drinking water. Do not fill it above the MAX mark. Place the cover back on
the reservoir and slide the reservoir back into the appliance.
2. Check that the steam controller is switched off (turned upwards). Switch on the appliance by pressing the
on/off button, after which the indicator light switches on. The indicator light next to the coffee button
flashes.
3. Now press the steam button. The indicator light next to the coffee button switches off and the light next to the steam button
flashes. When this light remains on, the water is at the right temperature.
4. Turn the steam pipe away from the appliance, use the provided handle for this.
5. Fill a cup with the drink that you want to heat up, (chocolate) milk. It is important that the cup used is not too small, observe
a minimum diameter of 7.5 mm and take into account that the drink can double in volume when foaming.
6. Remove the attachment from the steam pipe and place the steam pipe in the drink to be heated. If you also want to foam
your drink, leave the attachment on the steam pipe. Place the steam pipe in the drink to be warmed up. Make sure that the
end of the steam pipe is always in the drink (approx. 2 cm), and not only in the foam for example, to prevent liquid from
splashing upwards.
MAKING ESPRESSO/COFFEE
HEATING UP (CHOCOLATE) MILK
EN - 15
and firmly turn the handle counter-clockwise to position