Durabase WM 1010 Mode D'emploi page 104

FAILURE
The washing result is
not good.
The water is drained
from the machine as
soon as it is filled.
No water is seen in the
drum during washing.
There are residues of
detergent on the
clothes.
There are gray stains
on the clothes.
(**) See the section concerning instalations your machine.
PROBABLE CAUSE
Clothes exceeding the
maximum capacity
has been filled in your
machine.
Your water may be
hard.
Distribution of the
clothes in your
machine is not well-
balanced.
The end of the water
drain hose is in a
position too low
according to the
machine.
No failure. The water is
at the lower part of the
drum.
The pieces of some
detergents which do
not dissolve in water
may stick to your
clothes as white stains.
These stains may be
caused by oil,cream or
ointment .
103
METHODS OF
ELIMINATION
Put the clothes in your
machine in a manner
not to exceed its
maximum capacity.
Use the amount of
detergent according to
the declaration of the
detergent producer.
Spread the clothes
inside the machine in
an orderly and well-
balanced manner .
Place the water drain
hose in an appropriate
height.(**)
-
By calibrating your
machine for "Rinsing"
program,make an
additional rinsing or
eliminate the stains
After drying with the
help of a brush.
In the next washing
operation, use the
maximum detergent
amount declared by
the detergent producer.