HIKOKI BUMP & FEED Eco 4 Mode D'emploi page 5

7. Put the spool onto the cover at the position meet the
holding notches with the eyelets on the cover. (Fig. 13)
28. Line holding notch
29. Eyelet
30. Spool
31. Cover
8. Set the lines into the eyelets through the slits on upper
side of the eyelets. (Fig. 14)
32. Slit
33. Eyelet
9. Set the cover in to the housing, meet the eyelet to the
eyelet slots of the housing. (Fig. 15)
34. Eyelet slot
35. Eyelet
NOTE
Make sure that the latches of the housing fully spread in
each windows of the cover. (Fig. 16)
36. Windows of the cover
37. Latch of the housing
IMPORTANT!
The latches fully spread in the windows.
5
English