Fonexion ideus ITCOMBO100 Guide D'utilisation page 45

USER GUIDE
Call back
When the desired number is shown, press DIAL key or HANDSFREE (base or handset) key or
pick up the handset of the base to dial out the number.
Edit & copy incoming messages to phonebook
The user can store the incoming number to the phone book based on the following procedures:
Press UP (▲/CID) key once, LCD will show the last received record.
Press (▲/CID) or (▼/OUT) key to select the designated message.
Press SET/OK (MENU) key to enter, and press (▲/CID) or (▼/OUT) key to select "ADD
TO PB?".
Press SET/OK (MENU) key and the LCD show a flashing cursor at the name line. Key in
the name.
Press SET/OK (MENU) key to confirm the name, and the cursor will jump to the line of the
current number to allow you to modify the number, if necessary.
Press SET/OK (MENU) key to confirm, and the display shows "MELODY 1", the direction
keys key go through the ring melodies.
Press SET/OK (MENU) key to confirm the melody and store the number in your phonebook
View & dial out phone numbers from phonebook
There are 50 phonebook memories, each memory can store 12 characters and 20 digits.
In idle mode, press PHONEBOOK key.
Then press (▲/CID) or (▼/OUT) key to review the number.
When the desired number is shown on LCD, press the DIAL key or HANDSFREE (base
or handset) key or pick up the handset of the base to dial out the number automatically.
One-touch Memory on BASE
Store the number into one-touch memory
In on-hook state, pre-dial a number or scroll to the desired number
Press and hold Mi (i=1~10) key till a "DI DO" sound being heard, the number is stored.
Dial out number from one-touch memory
In on-hook or off-hook state, press Mi (i=1~10) key, the number is dialed out.
Page to all handsets (if have multi-handsets registered)
In on-hook state, press v key of the BASE, then press "9" on the keypad of the base to page
all registered cordless handsets (also you can select the handset number you want to page).
Then the handsets ringing.
Press key again to cancel the paging.
Intercom
The intercom feature is activated by pressing the INT key.
From Base
Press INT key once. If you have only one cordless handset registered to the base, the
display will show "CALLING HS1".
If you have more than one handset registered to the base, the display will show "HS?"
with the registered handset numbers above, and the base will output a continuous beep,
until you press the number for the handset you want to intercom. Then the display will
change, for example, to "CALLING HS2", if it is handset 2 that is being called.
ITCOMBO100
45
EN