Fonexion ideus ITCOMBO100 Guide D'utilisation page 44

ITCOMBO100
During the conversation, the phone number of the incoming call of the third party can be seen
in the unit.
This function can be worked when the user applied the Telecom service.
Auto timer
The timer will start automatically after the telephone line is engaged.
Flash (R)
Press R/CLR (FLASH) key to reset the line with our leaving the handset.
For PABX mode, this key can be used for special service.
Pause
Press REDIAL/P (RD/P) key will insert a time delay of 3.6 seconds while dialing a number.
Pre-dialing
The unit has pre-dialing function, you can enter and edit the number before dial it out.
The following procedure describes how to use this function:
In idle mode, input the number you want to dial out using digit key .if any mistake, press
R/CLR (DEL) key to edit.
Press DIAL key or HANDSFREE (base or handset) key once or pick up the handset of
the base. The unit will dial out the number show on the LCD.
Redial function
Press DIAL key or HANDSFREE (base or handset) key or pick up the handset of the
base.
Press REDIAL/P (RD/P) key, the last dialed number will be dialed again
Name matching
If you have edited the incoming message with different name, next time with the same phone
number will display the modify name.
Review /delete /call back incoming numbers
Review
In on hook state, press UP (▲/CID) key once and then use the direction keys (▲/CID) or (▼/
OUT) key to scroll and review the incoming numbers
Delete
When the desired number displayed on LCD, press R/CLR (DEL) key one time to delete it.
Call back
When the desired number is shown, press DIAL key or HANDSFREE (base or handset) key or
pick up the handset of the base to dial out the number.
Review /delete /call back outgoing numbers
Review
In on hook state, press DOWN (▼/OUT) key once and then use the direction keys (▲/CID) or
(▼/OUT) key to scroll and review the outgoing numbers
Delete
When the desired number displayed on LCD, press R/CLR (DEL) key one time to delete it.
44
EN
USER GUIDE