Fonexion ideus ITCOMBO100 Guide D'utilisation page 41

USER GUIDE
Press the direction keys key to select the INT RING and EXT RING setup.
Press SET/OK key to confirm.
Press the direction keys to select the MELODY and VOLUME setup.
If select MELODY
Press SET/OK key to confirm.
Press the direction keys to select desired melody, the corresponding melody sound can
be heard with the selection.
Press SET/OK key to confirm your selection.
If select VOLUME
Press SET/OK key to confirm.
Press the direction keys to select desired ringer volume 1- 5, if you want to switch off
select OFF.
Press SET/OK key to confirm your selection.
TONE SETUP
The user is able to change the handset tone settings.
Press SET/OK key, then using the direction keys to select TONE SETUP item.
Press SET/OK key to enter.
Press the direction keys to select the KEY TONE and BATTERY LOW, RANGE ALARM
setup.
Press SET/OK key to confirm.
Press the direction keys key to select the ON or OFF to enable/disable the sounding of
the beep respectively.
Press SET/OK key to confirm your selection.
Notes: If you turn the tone on for key tone, a beep for key tone will sound when a key is pressed
on the handset keypad in idle state. If you turn the tone on for battery low warning, a beep will
sound when the battery is low. If you turn the tone on for the out of range warning, a beep will
sound when the handset goes out of range of the base unit.
LANGUAGE
The handset will support up to 8 pre-defined languages.
Press SET/OK key, then using the direction keys to select LANGUAGE item.
Press SET/OK key to enter.
Press the direction keys key to select the language. Each language will display in its own
native translation.
Press SET/OK key to confirm your selection.
HANDSET NAME
The operation will allow the user to change the handset name
Press SET/OK key. Using the direction keys to select HS NAME
Press SET/OK key to enter.
Enter the handset label.
If you make a mistake, press R/CLR key to correct.
Press SET/OK key to confirm it.
AUTO ANSWER
The Handset can be set to answer an incoming call automatically by simply pick it up from the
charging cradle. The user is able to select to enable/disable the auto answer function.
ITCOMBO100
41
EN