Clatronic BS 1222 Mode D'emploi & Garantie page 40

42880-05-BS 1222
GB
• Insert the vacuum hose connection head (5) in the hose connection (12) until it
snaps mechanically into place. To release the hose, press the two clamps simul-
taneously inwards while pulling the connection head out.
• Insert the vacuum tube (2) on the shank (3).
Description of Components
1. Floor nozzle
2. Vacuum tube
3. Shank
4. Damper
5. Vacuum hose
6. On/Off switch
7. Vacuum power regulator
8. Carrying handle
9. Cable winding button
10.Cable
11.Dust bag change display
12.Hose connection
13.Dust bag compartment
1. Install the accessory. Adjust the telescopic tube as necessary.
2. Unwind the necessary cable length, insert the plug in a duly installed
230V/50Hz socket with protective contact and switch on the appliance with the
on/off switch (6).
3. Set the vacuum power level with the vacuum power regulator (7).
4. Start vacuuming at a constant speed. It is not necessary to press. Check that
you have not come to the end of the cable.
ATTENTION: Pay attention to the reach of the vacuum cleaner determined by the
cable length.
Vacuum power regulator (7)
Low suction strength: for curtains and delicate materials
Medium suction strength: for deep-file velvet carpets and delicate carpeting
High suction strength: for ordinary carpets and floors.
Telescopic vacuum tube:
The suction hose can be easily adjusted to your body size. Release the coupling by
pushing the locking button backwards. Adjust the suction tube as you like. Fasten
the suction tube by releasing the button.
40
10.03.2004 12:40 Uhr
Startup
Using the unit
Seite 40