Witter F92C Notice De Montage

MATERIALS
A 1 Cross Bar with European facing to 94/20/EC A50-1
C 1 Right Hand Side Arm
D 1 Left Hand Side Arm
E 4 M10 x 110 Bolts, Nuts, Lock Washers and Ø30Flat Washers
E1 4 Bushes (17mm O.D. - 79mm long)
F 2 M10 x 45 Bolts, Nuts, Lock Washers and 4 Ø20 Flat Washers
H 2 M12 x 40 Bolts, Nuts and Lock Washers and Ø25 Flat Washers
I 1 ZEP35 Electrical plate (not shown)
CB 2 M16 x 50 Coupling Bolts, Nuts and Lock Washers
FITTING
1. Remove plastic panel from underside of vehicle (3 large nuts). Release lower edge of bumper (4 large nuts on
underside of bumper).
2. Lower exhaust and remove heat shield to gain access to the chassis rails. Insert Bushes (E1) on Bolts (E) with
Large Flat Washers under bolt heads into the frame through the adjacent 'keyholes' and loosely attach Side Arms
(C) and (D).
3. Cut bumper extension as shown below. Note: The bumper extension is available from Ford as a separate clip on
item (part no. 1115579). NOT ZETEC S.
4. Pull down lower edge of bumper and insert Cross Bar (A). Loosely attach Cross Bar (A) to rear panel and Side
Arms (C) and (D) using Bolts (F) at upper mountings and Bolts (H) on lower mountings. Tighten all Bolts.
5. Re-mount heat shield and exhaust. Re-mount lower bumper edge. Re-fit plastic panel.
Note: This towbar must be used with either a Witter Towball (part number Z11) or Class A50-1 or A50-X towball dimensionally
Conforming to A50-1 with a 'D' and 'S' value greater than or equal to that of the towbar. Please refer to the vehicle specification for
the trailer weight and nose limits, which must be observed.
Recommended torque settings: Grade 8.8 bolts: M10 - 53 Nm, M12 - 95 Nm, M16 - 214 Nm
Witter-towbars.co.uk
Fitting
Instructions
W0001F92C-FIT$011103170000AÄ
W0001F92C-FIT$011103170000
TOWBAR
For FORD MONDEO
SALOON AND HATCH
(2001- )
F92C