Fleischmann TURN-CONTROL 6915 Instructions De Service page 28

1721_Betra_21_6915_0101.qxd
All connections of the TURN-CONTROL will be
found on the rear of the equipment (Fig. 2).
plug
(7-pole)
Fig. 2
You now have the following possible connections.
The power feed can be connected up to any of
the FLEISCHMANN transformers 6706, 6735,
6755 or 6811 by using the connecting cable 39
6865 as supplied, or to any transformer which
incorporates a 14-16.5 V continuous voltage
output (DC or AC), see Fig. 2.
Track connections and turntable connections
are made via the 7-pole plug. The location of the
wires can be seen above (Fig. 2) or shown on
28
27.09.2007
39 6865
14 ... 18 V
12:15 Uhr Seite 28
the rear of the equipment and are decribed in
the following chapter.
Connect up the wires first of all and then plug in
the transformer.
If you wish to use the TURN-CONTROL digitally
or via the LocoNet connection, then you will
also need a suitable length LocoNet cable! The
FLEISCHMANN article 6887 (2.15 m long) and
6888 (0.6 m long) would be best for this use.
Fig. 3 7-pole plug