Product Introduction; Front View; Rear View - CONTINENTAL EDISON CELED18HDU6 Manuel D'instructions

Product Introduction

Front View

(IR) Infrared Receiver: Receives IR signals from the remote control.
(Power on/Standby) LED indicator: Press POWER to turn on and off.
Indicator on(Red)
Indicator on(Green)
The effective receiving range for the signal is 5-8 metres from the front of the remote
control window, and 30
window.

Rear View

Wall Mounting
The TV is provided with mounting holes for a VESA (75x75mm)approved wallmounting bracket (NOT
SUPPLIED). Remove the Posi screws holding the base to the base bracket and lift the base away (do not
remove the basemounting bracket).Mount the VESA bracket using 4xM4x8mm ISO metric threaded
screws (not supplied). Do not use screws longer than 8mm, it will occur damage to the internal parts. Fit
the wall bracket securely following themanufacturers instructions.
LED indicator
Standby mode
Power on mode
0
to the left or right side and 20
INPUT:
Display the input source menu.
MENU:
Display/exit the OSD menu.
CH+/-:
Scan through channels.
VOL+/-:
Adjust the volume.
POWER:
Turn on/standby the TV set.
Remote Control window(keep clear)
0
above or below the control
Raccordements
Voir page suivante
4