Control Features - Neo Instruments Ventilator Mode D'emploi

III. CONTROL FEATURES
Although VENTILATOR is a digital device, it handles much like
an analog effect, with similar convenience and ease of use.
A good way to get to know the device is to start with this setup:
- Set Speed, Acceleration, Balance, and Distance to the 12
o'clock position.
- Turn Drive to the far left (off).
- Set the switch on the back to KEY for an organ, and to GIT
for guitar.
Bypass
This stomp-switch turns the rotary effect on and off. Its red LED
lights up when the device is bypassed (= effect off) and the
input signal is relayed to both outputs via a true bypass circuit.
Slow / Fast
This stomp-switch determines the speed of the rotary effect by
switching between slow and fast. As on the original, the bass
and treble rotors run out of sync at slightly different speeds.
Acceleration and deceleration times also differ, with the bass
rotor taking much longer to speed up and slow down.
One LED each indicates the respective rotor's current speed
(bass rotor = LO / yellow; treble rotor = HI / red).
18