Neo Instruments Ventilator Mode D'emploi page 17

Remote
This jack accepts the optionally available Ventilator Remote
footswitch or a Hammond CU-1 type Halfmoon switch to
remotely control the Slow / Fast function. It also gives you a kill
switch to stop the rotors. Note that when you stop the rotors,
the internal Slow / Fast button remains active.
Key / Git
Setting this switch to the KEY position activates
VENTILATOR's speaker simulation, which faithfully replicates
the frequency response of a 122 model Leslie. Use this
speaker simulation when playing an organ or organ sound over
a 'neutral' sound system such as studio monitors, high-quality
stage monitors, and PA cabinets.
If you are using a guitar plugged into a guitar amp, set the
switch to GIT to disable the speaker simulation. The device
then delivers a practically linear output signal, which prevents
the speaker simulation from coloring the amp's sound.
Depending on the speaker, amp, and your taste in tone, the
GIT setting can yield interesting results in combination with
organ sounds, as can the KEY setting with guitar amps.
12V DC
Connect the included AC adapter (12V DC, 2A) only; do not
use any other wall-wart or power supply. VENTILATOR cannot
be powered by batteries.
HEADS UP:
To ensure flawless operation, always connect all other cords
before you plug in the AC adapter.
17