Vollrath Mirage Cadet Manuel D'utilisation page 3

OPERATION
WARNING
Electrical Shock Hazard
Keep water and other liquids from entering the inside of the
unit. Liquid inside the unit could cause an electrical shock.
If liquid spills or boils over onto the unit, immediately unplug the unit
and remove cookware. Wipe up any liquid with a padded cloth.
CAUTION
Burn Hazard
Do not touch cookware, heating surface, food, or liquid while
heating. Remove cookware containing hot food or liquid from
the induction range before moving the induction range.
Hot food and liquids can burn skin. Induction heating surfaces heat
very rapidly. Use caution when adding pre-heated oil, liquid or other
food already in the cookware.
Turn on the Induction Range
1. Place the induction range on a flat stable surface.
2. Plug the power cord into a grounded electrical outlet that matches
the voltage on rating label.
NOTICE: This equipment requires a dedicated electrical circuit.
NOTICE: Using a voltage other than the nameplate rated voltage
will cause damage to the unit. Incorrect voltage,
modification to the power cord or electrical components
can damage unit and will void the warranty.Place the
induction-ready cookware containing food in the center
of the induction range.
NOTICE: Do not pre-heat empty cookware. Because of the speed
and efficiency of the induction range, cookware can very
quickly overheat and be damaged.
NOTICE: Do not drop cooking utensils or other objects onto the
cooking surface. The strong, non-porous surface will
break. The warranty does not cover this type of abuse.
3. Press and release . The Display panel will show a power level.
This indicates the unit is heating.
Adjust Power or Temperature
To Switch Between Power and Temperature Modes
Press and release .
To Switch Between Fahrenheit and Celsius
Press and release .two times.
To Adjust the Power Level or Temperature
1. Press and release to select Power or Temperature mode.
2. Press or to increase or decrease the power or
temperature.
®
Mirage Cadet Countertop Induction Range Operator's Manual
Cook Food
The display window should remain constant during operation. If the
display is flashing, see the TROUBLESHOOTING section in this manual.
Removing cookware from the cooking surface for more than ten
minutes will cause the unit to automatically turn off. Removing
cookware for less than ten minutes will not interrupt operation.
Use the Timer
1. Press and release . The display will show "1" with a flashing
dot in the lower right corner.
2. Press and release or
increments.
3. When the timer cycle is complete, the range will beep three times
and then turn off.
4. To cancel the timer, press
temperature mode.
Overheat Protection
This induction range is equipped with an over-heat protection feature. If
the temperature of the cooking surface becomes too hot, the unit will
turn off. The display will flash "F5" or "F6" to indicate the equipment is
in "over-heating protection" mode. After the equipment has cooled,
press the ON/OFF button. If display does not show "F5" or "F6", the
equipment has cooled and it is ready to resume cooking.
CLEANING
To maintain the appearance and increase the service life, clean your
induction range daily.
WARNING
Electrical Shock Hazard
Keep water and other liquids from entering the inside of the
equipment. Liquid inside the equipment could cause an
electrical shock. Do not spray water or cleaning products.
Liquid could contact the electrical components and cause a
short circuit or an electrical shock.
CAUTION
Burn Hazard
Allow equipment to cool before moving or cleaning. Cleaning a
hot surface with a wet sponge could result in a burn from the
steam. Some cleaning products can produce noxious fumes
when applied to a hot surface.
NOTICE: The cooking surface remains hot even when this
equipment is turned off.
NOTICE: Do not use abrasive materials, scratching cleansers or
scouring pad to clean the equipment. These can damage
the finish.
1. Press and release .
2. Unplug the cord from the wall outlet.
3. Allow the equipment to cool.
4. Wipe the exterior with a clean damp cloth.
5. Thoroughly wipe off any mild soap or chemical cleaners.
to set the timer in full-minute
. The range will return to power or
3