OHAUS STARTER 300C Mode D'emploi page 7

STARTER 300C Portable Conductivity Meter
Controls
Button Press & release
- Start or endpoint
measurement
- Confirm setting, store entered
value
- Start calibration
- Meter on
- Back to measurement screen
- Store current reading to
memory
- Increase value during setting
- Scroll up through the memory
- Switch between conductivity
and TDS measuring modes
- Decrease value during setting
- Scroll down through the
memory
- Start self-diagnosis
Press & hold
for 3 seconds
- Turn auto endpoint on / off
,
- Review the latest calibration
data: cell constant
- Meter off
- Recall stored data
- Enter setup mode
EN 3
-