turck FTCI LI-UP8X Série Manuel D'instruction page 7

Parameter and Functions
Parameter
0 Cod
1 USP
2 SP
3 hS
4 OU
5 dS
6 dr
7 nF '
8 GLY
9 CAL
10 Cod
Technical data (s. also page 10)
Operating voltage: 24 ± 10 % VDC
Current consumption:
Switching output:
Switching current:
Aalogue output:
Last R :
L
Operating range:
depending on device (s. page 10)
Temperature monitoring:
Switch-on delay:
Switch-off delay:
Availability time:
Response time:
Housing material:
Flow rate display: 7-segments/3 digits
Connection: 4-pole, M12 x 1
Hans Turck GmbH & Co.KG • D–45466 Mülheim/Ruhr • Tel. 0208/4952-0 • Fax 0208/4952-264 • E-Mail: turckmh@turck.com • www.turck.com
Parameter value
0...255
L or °C
MIN +0,2...MAX
or -9...90 -9...90 -9...90 -9...90
-9...90
0,2...2/5/10
or 1...10
nO or nC
0...50
0...50
1, 2, 4, 8
0...30
0...255
If flow rate monitoring is selected
for S1
< 100 mA Adjustable range for S1 [l/min]:
PNP, NO/NC depending on device (s. page 10)
progr. Hysteresis for S1 [l/min]:
< 200 mA depending on device (s. page 10)
4...20 mA
200...500 Ω
If temperature monitoring is
selected for S1
Adjustable range for S1:
-10...90 °C Hysteresis for S1:
0...50 s
0...50 s
6...10 s
1...8 s
PBT
Function
Enter access code Factory setting 0
Unit switch point S1 [l/min oder °C]
Adjustable range switch point S1 [l/min or °C] (see page 10)
Hysteresis switch point S1 [l/min or °C] (see page 10)
Output switch point S1 [N.O./N.C.]
Switch-on delay switch point S1 [s]
Switch-off delay switch point S1 [s]
Average value [s]
Selection of glycol contents in 5-%-Steps
Display correction [+/-25 %]
Modification of access codes
-9...+90 °C
1...10 °C
7
/0705