WMF STELIO Mode D'emploi page 10

Start-up
Prior to initial use or when the automatic coffee maker has not been operated
over a long period, fill the appliance with the maximum amount of water but
without coffee powder, let the water boil and finally rinse the filter and pot with
hot water.
Setting the current time
After connecting the power plug to a socket the display will
flash 12 00. Set the current time by pressing the buttons h and min. As soon as
the colon starts flashing, the clock is set and running, a further confirmation is
not required. You can change the current time at any time by pressing the h and
min buttons.
Note: After a power failure or after the power plug has been disconnected, the
time must be reset.
Programming the Auto-On time
The Auto-On system of the appliance automatically starts the brewing process at
the set time. The Auto-On time can be programmed up to 24 hours in advance.
It is displayed when you press the set button and BREW appears in the display.
Keep the set button pressed and set the required Auto-On time by pressing the
buttons h and min.
Note: After a power failure or after the power plug has been disconnected, the
Auto-On time must be reset.
Brewing coffee
Open the rear cover on the appliance and pour cold water into the reservoir. The
water level indicator on the reservoir shows the quantity of fresh water required
to brew the desired number of cups à 125 ml coffee. The scale on the handle of
the glass pot refers to cups of brewed coffee à 125 ml.
Note: If you have accidently filled in too much water, you can pour it out
through the rear overflow outlet. Do not tilt the appliance forward to empty the
reservoir.
To fill in coffee powder, open the front cover. Fold a paper filter size 1 x 4 along
the fold lines and insert it into the filter. The paper filter is not allowed to stick
out beyond the rim of the filter and must therefore be pressed slightly into place
by hand.
Fill in the required quantity of coffee powder. Depending on your personal taste,
use approximately 5 to 7 grams of medium ground coffee per cup. If the coffee
powder is ground too finely, the filter may overflow.
Auto-On function
If you want the brewing process to start up automatically at the programmed
Auto-On time, press the Start/Stop button once. AUTO will appear in the display
and the indicator light lights up red. After the appliance has switched on auto-
matically at the programmed time, the indicator light will go out, the indicator
light will light up green and the brewing process will start.
10