tomado TIH5501B Mode D'emploi page 18

BEFORE FIRST USE
Before you use the appliance for the first time, please do as follows: Carefully unpack the appliance and remove all
the packaging material. Keep the material (plastic bags and cardboard) out of reach of children. Check the appliance after
unpacking for any damage, possible from transportation. Clean the glass with a damp cloth. Check that the voltage in your
home corresponds with the voltage printed on the bottom of the appliance. Follow the installation instructions in the chapter
INSTALLATION INSTRUCTIONS.
OPERATION OF THE APPLIANCE
Use only suitable cookware on the induction hob .
After the mains voltage is applied all displays can light up for a moment. After that, the hob is in stand-by mode
and is ready for use.
The hob is controlled with electronic sensors which are operated by touching the related keys. Each sensor activation
is followed by a sound signal.
SWITCHING THE APPLIANCE ON
Switch the hob on by touching the ON/OFF key for a few seconds. The displays of the cooking zones all show [0] and the dots blink.
If there is no cooking zone selected within 60 seconds, the hob will automatically shut off.
SWITCHING THE APPLIANCE OFF
Switch the hob off at any time by touching the ON/OFF key for a few seconds.
The ON/OFF key always has priority in the switch off function.
SWITCHING ON A COOKING ZONE
Press on the key of the cooking zone you wish to use. The display of the selected cooking zone shows [0].
Place the pan on the cooking zone. Select the heat setting by using the increase heat setting key + or the decrease heat setting key -.
To get food quickly to the boil, select the desired heat setting and touch the P key to activate the Boost function.
BOOST FUNCTION
The Boost function gives extra power and can be activated for one cooking zone at a time. A cooking zone must be selected,
the heat setting set on the desired setting and the key (Boost) must be pressed. The Boost function is activated when
a P appears in the display of the selected cooking zone.
After 5 minutes the Boost function will automatically switch off and the power will return to the selected heat setting.
The Boost function is being cancelled automatically as soon as another cooking zone is activated. Attention: the Boost function
can only be used with one active cooking zone at a time.
In that case the power of the second cooking zone will be decreased automatically. The necessary power reduction is shown
by blinking of the corresponding cooking zone display. The display will blink for 3 seconds and during that time further
adaptations of the settings are allowed before the power is automatically reduced.
SWITCHING A COOKING ZONE OFF
Select the cooking zone you want to switch off by pressing the corresponding key. Touch the - key to decrease the heat
setting to [0]. By pressing the keys + and - simultaneously, the setting turns directly to [0].
If the cooking zone is hot, the displays shows an [H] instead of [0].
EN - 18