Technical Specifications - Grizzly EMH 2440 Traduction De La Notice D'utilisation Originale

• Damage resulting from material or
manufacturing defects shall be rem-
edied by replacement or repair free of
charge.
• Our service centre will also repair parts
not covered by guarantee for a fee.
The service centre will be pleased to
give you a cost estimate.
We can only repair equipment with suf-
ficient postage and packaging by the
sender.
• This requires you to return the non-
dismantled unit together with its
receipt slip and warranty card to our
Service Centre.
• We will not accept bulk consign-
ments, express or other special
freight where postage has not been
paid for.
• We will dispose of your equipment free
of charge.

Technical specifications

Blade-type shredder ............. EMH 2440
Nominal power intake
............................. 2400 W, S6 40% 100s*
Nominal voltage .......... 220V-240 V, 50 Hz
Safety class .......................................
Degree of protection .......................... IP24
Idling speed (n) .........................3940 min
Branch thickness ................max. 40 mm**
Volume of collection bag................ca. 60 l
Weight ..............................................12 kg
Guaranteed sound power level
...................................................107 dB(A)
Measured sound power level (L
.........................104,7 dB(A); K
Acoustic pressure level (L
.......................... 97,5 dB(A); K
The sound levels have been determined
in accordance with noise measuring pro-
cess EN 13683:2009-09, appendix F.
*
** The max. branch thickness that can
Do not exceed the maximum permitted
network impedance of 0,30 Ohms at the
electrical connection point. To be on the
safe side, check with your local electric
utility to verify that the junction point of the
mains has enough continuous current car-
rying capacity for the unit.
Noise and vibration values were deter-
mined according to the standards and
II stipulations mentioned in the declaration
of conformity.
Technical and optical changes can be car-
-1
ried out in the course of further develop-
ment without notice. All dimensions, refer-
ences and information of this instruction
manual are therefore without guarantee.
Legal claims, which are made on the ba-
) sis of the instruction manual, cannot thus
wA
= 2 dB(A) be considered as valid.
wA
)
pA
= 3 dB(A)
pA
Continuous-operation periodic duty
(40 s on - 60 s idle)
be chaffed is dependent on the type of
wood and the quality of the goods be-
ing cut.
For hard wood (e.g. oak/beech
branches), the max. branch thickness
that can be chaffed is less than for
soft wood (e.g. pine/spruce wood). For
dry or knotted wood, the cutting thick-
ness may also be less.
UK
71