Overload Protection; Restart Prevention; Working Methods; General Working Instructions - Grizzly EMH 2440 Traduction De La Notice D'utilisation Originale

Overload protection

In the event of overload, e.g. due to
branches that are too thick, the equipment
automatically switches off.
To restart, allow the equipment to cool
then switch it back on.

Restart prevention

The unit will not automatically restart
when the power returns after a power cut.
To restart the unit, press the On switch.

Working methods

General working instructions

Keep enough distance to the
shredder since long branches can
be spun off while being drawn into
the shredder.
Wear ear and eye protection
Wear hand protection
• When feeding branches to the unit,
keep holding them until they are auto-
matically drawn in.
• Adapt to the speed of the shredder
and avoid overloading the unit.
• To avoid the unit clogging up, mix the
branches with twigs and gardening
waste allowed to wither for several
days.
• To prevent the blades from becoming
blunt quickly, remove mud and stones
from the roots before shredding.
• Do not shred but directly compost all
soft and wet material such as kitchen
waste.
• Keep a couple of dry branches to use
them for cleaning the unit at the end.
• Do not turn off the unit until all the ma-
terial has passed the blades. Remain-
ing material may otherwise block the
blade when you restart the unit.

Freeing up a jam

D
Before starting to service or clean
the unit, turn off the unit, pull the
power plug, and wait until the blade
stands still. There is a risk of injury
and a risk to life from electric shock,
fire and rotating blades.
• Check that the power plug (
pulled properly.
• Unlock the housing interlock (8).
• Tip forward the front part of the shred-
der housing. You can remove it com-
pletely and put it aside.
• You now have full access to the
blades (18).
• Remove the blockage.
Sharpening, turning or replacing
the blades
Before starting to service or clean
the unit, turn off the unit, pull the
power plug, and wait until the blade
stands still. There is a risk of injury
and a risk to life from electric shock,
fire and rotating blades.
D
• Check that the power plug (
pulled properly.
• Unlock the housing interlock (8).
• Tip forward the front part of the shred-
der housing. You can remove it com-
pletely and put it aside.
• You now have full access to the blade
(18).
• Use a screwdriver to block the blade
plate (16). Slot the screwdriver into
the access hole (19) and carefully turn
the blade plate (16) until one of the
UK
7) is
A
A 7) is
69