WOLFF FLAMENCO Traduction Du Mode D'emploi Original page 16

6.2 Description of grinding, milling and cleaning discs
Paper grinding discs double sided, 375 x 40mm
Grade 16,
Grade 24,
Grade 40,
Grade 60,
Grade 80,
Grinding gauze double sided, 400mm
Grade 60,
Grade 80,
Grade 100,
Grade 120,
Grade 180,
Carbide grinding disc
Dismounting action much more aggressive compared to paper disc. High grinding efficiency. High tool life
(10 times higher as paper grinding discs).
Disc does not clog, due to open grains. Disc can be cleaned. Silicone or wax-spray can be used additionally
to reduce adhesion.
Grade 16,
Grade 24,
Cylindrical brush disc, #015735
For preparing new anhydrite- and magnesia-screeds.
For abrading of anhydrite- screed, for abrading areas contaminated with paint, mortar, felt-, foam- and
adhesive residues.
Corrugated steel-brush disc, #013539
For brushing and preparation of subfloors. For removing the loose sintered material on new anhydrite- and
magnesia screed.
Flat steel brush disc #015738
For removal of foam, felt and hessian backing residues. For abrading anhydrite and self-levelling screeds, for
industrial cleaning. Brush length 45 mm. The open brushes work well with tacky residues. The brushes do not
clog.
Grinding disc with 6 stones K20 #013540
For grinding uneven areas of screed and levelling compounds, paint or gypsum residues. Sharp edges give
high efficiency.
System-milling-disc
The system milling disc can be equipped with different interchangeable milling modules. The system-discs
are available complete, or, as single modules
Use:
System carbide milling disc,
#013569: for removing thick adhesive residues and fibre-, felt- and foam residues (scraping action)
System diamond milling disc, #020943
for grinding extremely hard smoothing compounds and industrial floors, as well as epoxy- and polyester coatings
Einscheibenschleifmaschine FLAMENCO, #053365
#013531,
#013527,
#013528,
#013529,
#013530,
#013548,
#013331,
#013332,
#013333,
#013549,
#013510, Abrading of anhydrite-screed, removing of dirt and adhesive residues
#013517, For abrading and rough grinding
Grinding of subfloors
Preparing and grinding of dirty screeds
Grinding and levelling smoothing compounds
Finish-grinding of smoothing compounds
Grinding and abrading timber surfaces
Grinding of parquet varnish, coatings and old surfaces
Fine-grinding of surfaces
Fine-grinding of surfaces
Fine-grinding of surfaces
Fine-grinding of surfaces,
grinding/polishing of parquet + cork
16