Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Adjust Cutting Length
•
First remove the protective cap from the shaving head.
•
Fit a comb attachment according to your desired hair length. The size of the hair length
setting is displayed in the center of the comb attachment.
•
In order to fit a comb attachment, hold it with the teeth pointing upwards. The labeling
of the comb attachment should remain visible on the back. Slide the comb attachment
onto the shaving head and press it in so that it clicks into place.
Cut Hair / Beard
•
Select the cutting length.
•
Connect the mains plug to a properly installed isolated ground receptacle 230 V~ /
50 Hz.
•
Slide the On/Off switch (2) to position "1".
NOTE:
•
Start by using the biggest comb attachment and cut your hair/whisker step by step to
the desired length.
•
The hair length adjuster (3) allows you to set the exact cutting length and to use the
comb attachments effectively.
Outlining and Shaving the Neck
•
The clipper head allows outlining the shape of the beard, even in difficult to reach places
as well as shaving the hairline at the neck.
•
Turn the hair clipper off with the switch (2).
•
Remove the comb attachment and turn the device on again.
Finish Operation
Slide the On/Off switch (2) after use to the position "0" and disconnect from the mains.
Regular cleaning and maintenance ensures optimum results and long lifetime.
WARNING:
•
Turn the device off and disconnect the mains plug.
•
Do not submerge the unit in water. This would cause electric shock or fire.
Cleaning and Maintenance
GB
33
Publicité
Table des Matières
