Hkoenig EXP350 Mode D'emploi page 4

or the shape is not fit
used skimmed milk
*If you have not been able to solve the problem, contact customer support in your country
Note: Purge steam to clean steam nozzle after use, warning hot surface.
D. MAKE HOT WATER
1. Put a stainless steel container under steam nozzle；
2. Open knob after coffee indicator always lights on, and then hot water is
ejected from the steam nozzle;
3. Close knob when the desired amount is reached.
Note: Check frequently the water level in the tank. Refill if necessary.
Do not touch the hot surfaces of the machine with hands,
especially brewing outlet, steam nozzle when use machine.
E. HEATING LIQUID
1. Use a stainless steel cup, pour cold liquid to 1/2 cup；
Note: Cup diameter should not less than 70 ± 5mm.
2. Press steam button, it start preheating, and steam indicator is flashing, then
wait for lamp lights on；
3. Put cup under steam nozzle；
4. Turn on the knob, release steam，let the steam nozzle is inserted into the
liquid;
5. Turn off the knob when the desired temperature is reached.
Note: When steam is stopped, clean the steam nozzle immediately, and
release the liquid in the pipe, to prevent the liquid scaling, because
the surface temperature of steam pipe is very high when in use, be
careful not to be scalded.
Use whole milk
INDICATOR TIPS
Coffee Steam
Cause
Indicator Indicator
Flashing Lights on Power on
Pre-heating
Flashing Lights off
coffee
Coffee
Lights on Lights off Pre-heating
finished
Pre-heating
Lights off Flashing
Steam
Pre-heating
Lights off Lights on
finished
Temperature
Flashing Lights off
too high
NTC
Flashing Flashing circuit or short
circuit
Making hot water
Flashing Lights off
too long
Making coffee for
Lights off Flashing
too long
Solution
/
/
/
/
/
Wait temperature naturally
is
fall or press coffee button
boil water to cooling
is open Please contact with the
authorized service facility
for repairing.
Turn off the knob
Turn off the knob