Samsung HW-J250 Mode D'emploi page 17

▶ Bluetooth POWER on (Bluetooth POWER)
When the Bluetooth Power On function is on and the Soundbar is turned off, if a previously paired Bluetooth device
tries to pair with the Soundbar, the Soundbar turns on automatically.
1. To turn Bluetooth Power ON, press the Bluetooth POWER button on the remote while the Soundbar is turned
on.
2. The Green or Red
Bluetooth POWER
ON
OFF
Available only if the Soundbar is listed among the Bluetooth device's paired devices. (The Bluetooth device
●
and the Soundbar must have been previously paired at least once.)
The Soundbar will appear in the Bluetooth device's searched devices list only when the Bluetooth LED is
●
blinking.
In the TV SoundConnect mode, the Soundbar cannot be paired to another Bluetooth device.
●
▶ To disconnect the Bluetooth device from the Soundbar
You can disconnect the Bluetooth device from the Soundbar. For instructions, see the Bluetooth device's user manual.
The Soundbar will be disconnected.
●
When the Soundbar is disconnected from the Bluetooth device, the
●
▶ To disconnect the Soundbar from the Bluetooth device
Press one of the other mode buttons on the remote control or the (
switch from to another mode or turn off the Soundbar.
The connected Bluetooth device will wait a certain amount of time for a response from the Soundbar before
●
terminating the connection. (Disconnection time may differ, depending on the Bluetooth device)
In Bluetooth connection mode, the Bluetooth connection will be lost if the distance between the Soundbar
●
and the Bluetooth device exceeds 16.25 ft. (5 m).
The Soundbar automatically turns off after 5 minutes in the Ready state.
●
More About Bluetooth
Bluetooth is a technology that enables Bluetooth-compliant devices to interconnect easily with each other using a
short wireless connection.
A Bluetooth device may cause noise or malfunction, depending on usage, if:
●
- A part of your body is in contact with the receiving/transmitting system of the Bluetooth device or the
Soundbar.
- It is subject to electrical variation from obstructions caused by a wall, corner, or office partition.
- It is exposed to electrical interference from same frequency-band devices including medical equipment,
microwave ovens, and wireless LANs.
Pair the Soundbar with the Bluetooth device while they are close together.
●
The further the distance between the Soundbar and Bluetooth device, the worse the quality is.
●
If the distance exceeds the Bluetooth operational range, the connection is lost.
In poor reception areas, the Bluetooth connection may not work properly.
●
The Bluetooth connection only works when it is close to the unit. The connection will be automatically cut off if the
●
Bluetooth device is out of range. Even within range, the sound quality may be degraded by obstacles such as
walls or doors.
This wireless device may cause electric interference during its operation.
●
, White , and Green LEDs appear on the Soundbar's display.
LED
Green , Green and White
Red , Green and White
will blink on the Soundbar's top display.
) button on the main unit's top panel to
17
FUNCTIONS
blink
blink