Switching Function - Monacor KB-100 Mode D'emploi

4.7 Calling up a camera menu
If the setup menu of a camera can be acti vated
via the save command for a preset number,
the key [MENU] can be used for this purpose
(instead of a more complicated input, e . g . [9]
 [5]  [PRESET]) .
The joystick can be used to navigate in the
menu () or to change a setting () .
To call up a submenu, to confirm a change
or to activate a function, press the key [CLOSE] .
4.7.1 Calling up the menu for
AXC-3557PTZ / 3558PTZ
The setup menu of camera AXC-3557PTZ /
AXC-3558PTZ will be activated when preset
number 95 is called up:
[9]  [5]  [CALL]
Note: When the camera menu is called up frequently
and when the key [SCAN] or [TOUR] is not used, the
key can be assigned to activation of the menu (
ter 3 .2 .5) .

4.8 Switching function

Some cameras offer switching functions to be
activated via the control commands SET/ CLEAR
AUXILIARY . They can be used to control, for
example, heating, ventilation or illumination .
This way, four functions can be activated or
deactivated via the controller if the camera sup-
ports this feature .
1) Use the numeric keys [1] ... [4] to enter the
number of the corresponding function .
If the number is not correct, use the key
[CLEAR] to delete it .
2) Press the key [AUX] .
The display will briefly show
the corresponding control command SET AUX-
ILIARY will be sent .
To deactivate, proceed in the same way . The
display will briefly show
corresponding control command CLEAR AUX-
ILIARY will be sent .
Note: When [5] ... [8]  [AUX] is entered, only the con-
trol command SET AUXILIARY will be sent .
All rights reserved by MONACOR
be reproduced in any form or by any means for any commercial use.
chap-
☞
... and
AUX : ON
... and the
AUX :OFF
INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may
®
5 Specifications
Interface: � � � � � � � � � � � � � � RS-485
Connection: � � � � � � � � � � � � plug-in screw terminals
Baud rate: � � � � � � � � � � � � � 1200 bit/s
Protocols: � � � � � � � � � � � � � Pelco-D
Ambient temperature: � � � � 0 – 40 °C
Power supply: � � � � � � � � � � ⎓ 12 V / 500 mA
Dimensions (W × H × D): � 205 × 85 × 168 mm
Weight: � � � � � � � � � � � � � � � 550 g
Subject to technical modification .
2 × A+ /B−
2400 bit/s
4800 bit/s
9600 bit/s
19 200 bit/s
Pelco-P
Samsung
Panasonic
15