Sun Microsystems 365-1383 Mode D'emploi page 13

Select To
select one of the four corners that
LANDING needs color correction due to
influence from the earth's magnetism
ADJ correct the color at one of the four
corners of the screen
LANDING ADJUST
turn the moire cancellation function
"ON" or "OFF." CANCEL MOIRE
CANCEL MOIRE *
must be "ON" for "
ADJUST)" to appear on the screen.
ADJ adjust the degree of moire
cancellation
MOIRE ADJUST
* Moire is a type of natural interference which produces soft or
wavy lines on your screen. It may appear due to interference
between the regulated pattern of the picture from the input
signal and the phosphor pitch pattern of the CRT.
Example of moire:
4
Press the >?// buttons to adjust the settings.
For Press
/ . . . to shift red shadows to the right
and blue shadows to the left
H CONVERGENCE
? . . . to shift red shadows to the left
and blue shadows to the right
/ . . . to shift red shadows up and blue
shadows down
V CONVERGENCE
? . . . to shift red shadows down and
blue shadows up
/ . . . to shift red shadows up and blue
TOP
shadows down
V CONVER TOP
? . . . to shift red shadows down and
blue shadows up
For
BOT
V CONVER BOTTOM
ADJ (MOIRE
LANDING
ADJ
LANDING ADJUST
CANCEL MOIRE
ADJ
MOIRE ADJUST
Note
The picture may become fuzzy when CANCEL MOIRE is set to
"ON."
The OSD automatically disappears after about 30 seconds.
To close the OSD, press the
To reset, press the
The selected item is reset to the factory setting.
Getting Started
Customizing Your Monitor
Press
/ . . . to shift red shadows up and blue
shadows down
? . . . to shift red shadows down and
blue shadows up
/ or ? . . . to select the corner of the
screen you want to adjust
: top left
: bottom left
/ or ? . . . to reduce any irregularities in
the color to a minimum
50
/ . . . to turn CANCEL MOIRE "ON"
OFF ON
? . . . to turn CANCEL MOIRE "OFF"
OFF ON
/ or ? . . . to adjust the screen until the
moire is at a minimum
50
button again.
(reset) button while the OSD is on.
: top right
: bottom right
EN
F
ES
C
13