Customizing Your Monitor; Adjusting The Picture Brightness And Contrast - Sun Microsystems 365-1383 Mode D'emploi

Getting Started
2
Press the ¨./> and >?// buttons to select "
OPTION," and press the
The OPTION OSD appears.
3
Press the ¨./> buttons to select "
4
Press the >?// buttons to select "AUTO" or
"MANUAL."
The OPTION OSD automatically disappears after about 30
seconds.
To close the OSD, press the
For more information on using the OSD, see "Introducing
the On-screen Display System" on page 9.
8
button again.
OPTION
ON
ZZ... 1 MIN
UNLOCK
MANUAL DEGAUSS
(INPUT)."
OPTION
AUTO MANUAL
ZZ...
1 MIN
UNLOCK
INPUT
button again.

Customizing Your Monitor

Before adjusting
• Connect the monitor and the computer, and turn them on.
• Select " LANG" in the MENU OSD, then select
"ENGLISH" (see page 16).
Adjusting the Picture Brightness
and Contrast
Once the setting is adjusted, it will be stored in memory for
all input signals received.
1
Press the ¨ (brightness) ./> or > (contrast) ?//
buttons.
The BRIGHTNESS/CONTRAST OSD appears.
2
For brightness adjustment
Press the ¨./> buttons.
> . . . for more brightness
. . . . for less brightness
For contrast adjustment
Press the >?// buttons.
/ . . . for more contrast
? . . . for less contrast
The OSD automatically disappears after about 3 seconds.
To reset, press the (reset) button while the OSD is on.
The brightness and contrast are both reset to the factory
settings.
* The horizontal and vertical frequencies for the received input
signal appear in the BRIGHTNESS/CONTRAST OSD.
BRIGHTNESS/CONTRAST
26 26
80.0kHz/ 75Hz
Horizontal Vertical
Frequency* Frequency*