Dometic PERFECTVIEW Switch200VTO Instructions De Montage Et De Service page 13

SWITCH200VTO
6.3 Connecting the control box
A
NOTICE!
Ensure that all cables are connected correctly. The yellow control cable may never be
connected to earth; doing so can damage the device. Insulate the end of this control
cable when it is not in use and not connected.
➤ Connect the red cable (fig. 5 1, page 5) to an active positive cable (such as terminal 15).
➤ Connect the black cable (fig. 5 2, page 5) to earth.
I
NOTE
On some vehicles, the reversing light only works when the ignition is switched on. In
this case, you must switch on the ignition to identify the positive and earth cables.
➤ Connect the green cable (fig. 5 3, page 5) to the positive cable of the reversing light.
➤ Only connect the yellow cable (fig. 5 4, page 5) to the AMP Quadlok plug contact if your
monitor or multimedia navigation system requires an additional camera activation signal.
Details about the pin configuration for the contacts of your multimedia navigation system or
monitor can be found in the operating manual of your device.
➤ Connect the vehicle camera to the Camera 1 input (fig. 5 7, page 5).
➤ If you would like to connect a trailer camera:
connect the trailer camera to the Camera 2 input (fig. 5 8, page 5).
➤ If your monitor has a cinch audio input:
Connect the audio input of the monitor to the audio output (fig. 5 10, page 5) of the control
box.
➤ Insert the cinch plug of your video adapter into the video output (fig. 5 11, page 5).
If you would like to switch between the two connected cameras manually, you need to connect the
rocker switch supplied.
➤ Select a suitable installation location for the rocker switch, such as on the dashboard near the
monitor.
A
NOTICE!
Before drilling any holes, ensure that no electrical cables or other parts of the vehicle
can be damaged by drilling, sawing and filing.
➤ Drill a hole approximately 20 mm in diameter.
➤ Mount the rocker switch.
➤ Connect the 4-pin socket of the rocker switch with the 4-pin plug (fig. 5 5, page 5) of the
control box.
EN
Installing and connecting the control box
13