Reset Of A Receiver (Control Unit) To Factory Settings - Huwil E-Verso Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 41
10. Reset of a receiver (control unit)
to factory settings
By restoring factory settings all matchings of connected remote controls will be
deleted, too.
This can for example become necessary if a remote control goes missing.
Use this function if you think that a remote control that was programmed
by mistake is in reach. This could lead to cabinet flaps moving without
apparent reason.
Please proceed as follows:
10.1
Pull the plug for at least ten seconds.
10.2
Plug it back in and move the cabinet flap by hand at least 10 cm within the
following minute.
10.3
Pull the plug again for at least ten seconds.
10.4
Plug it back in and move the cabinet flap by hand at least 10 cm within the
following minute.
After this procedure all remote controls will have been deinstalled.
10.5
Make sure that none of the remote controls operates.
10.6
Reinstall the remote controls as desired.
Proceed according to point 6.
30
© HUWIL 02/2009 Huwilift E-Verso / E-Strato / E-Senso/ E-Senso+

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

E-stratoE-senso

Table des Matières