SCHOLTES TRP 741 OL Mode D'emploi page 14

Start-up and use
! The glue applied on the gaskets leaves traces of
GB
grease on the glass. Before using the appliance, we
recommend you remove these with a special non-
abrasive cleaning product. During the first few hours
of use there may be a smell of rubber which will
disappear very quickly.
! A few seconds after the hob is connected to the
electricity supply, a buzzer will sound. The hob may
now be switched on.
- +
! If the or button is pressed for an extended
period of time, the display scrolls quickly though the
power levels and timer minutes.
Switching on the hob
To switch the hob on, press and hold the
for approximately one second.
Switching on the cooking zones
To begin using a cooking zone, set the desired power
-
level using the
• Press and hold the
seconds: the cooking zone will immediately begin
operating at its maximum power level (16).
• Press and hold the
seconds: the cooking zone will operate at power
level 2 (slow cooking function).
Power function*
The power function for the cooking zones may be used
to shorten heating-up times. Activate and set the power
level for the desired cooking zone as described in the
previous paragraph. Press the power button
display, which indicates the power level, will alternately
show the letter „P" and the power level set previously
until the desired power level has been reached.
Once this level has been reached, the display will
revert to showing the set power level. To deactivate
this function, press the
a different power level between 0 and 16 using the
power level selector buttons.
*
Only available in certain models.
14
+
and .
+
button for approximately 2
-
button for approximately 2
p p
ower ower
button again or select
Switching off the cooking zones
To switch off a cooking zone:
• Press the
will progressively decrease until it is switched off.
• Alternatively, the
pressed simultaneously: this immediately returns the
power setting to 0 and the cooking zone switches
off.
Programming the cooking duration
! If the
extended period of time, the timer scrolls quickly
through the minute values in the corresponding
direction.
button
! All the cooking zones may be programmed
simultaneously, for a duration between 1 and 99
minutes.
1. Select the cooking zone using the corresponding
selector button.
2. Adjust the power level of the cooking zone.
3. Press the
light corresponding to the selected zone will start
flashing.
4. Set the cooking duration using the
buttons.
5. Confirm by pressing the
selection occurs after 10 seconds.
The timer begins counting down immediately. A buzzer
sounds for approximately 1 minute and the cooking
zone switches off when the set programme has
finished. Repeat the above procedure for each hotplate
p p
ower ower
.The you wish to programme.
Using multiple programmes and the display
If one or more hotplates are programmed, the display
will show the data for the hotplate with the least time
remaining, and the light corresponding to the position
of the hotplate will flash. The lights corresponding to
the other hotplates programmed will be switched on.
To visualise the time remaining for the other
programmed hotplates, press the
repeatedly: the time remaining for each hotplate will be
shown sequentially in a clockwise order,
starting from the front left hotplate.
-
button: the power of the cooking zone
- +
and buttons may be
and buttons are pressed for an
programming button. The indicator
button or automatic
and
button