Kyocera DF-710 Manuel D'utilisation page 21

Emptying the Waste Hole Punch Box
If a message is displayed on the machine operation panel indicating that the waste punch
box is full, be sure to empty the scraps in the waste hole punch box.
Leave the main power switch on the machine switched ON ( | ) while performing this
procedure.
1
Open the front cover.
2
Grasp the waste hole punch box handle and
remove the box from the Document Finisher.
NOTE:
punch scraps when removing the container.
3
Dispose of the hole punch scraps appropriately.
4
Re-install the waste hole punch box. Align it with
the guides in the Document Finisher.
5
Close the front cover.
DF-710, MT-710, BF-710, PH-5A, PH-5B AND PH-5C OPERATION GUIDE
Take care not to spill the waste hole
English
19