i.safe MOBILE IS740.2 Mode D'emploi page 5

Measures must be taken to prevent any accidental restarting of the device. Measures must be taken to prevent any accidental restarting of the device.
The safety of the device may be compromised, if, for example: The safety of the device may be compromised, if, for example:
Malfunctions occur. Malfunctions occur.
The housing of the device shows damage. The housing of the device shows damage. The housing of the device shows damage.
The device has been subjected to excessive loads. The device has been subjected to excessive loads. The device has been subjected to excessive loads.
The device has been stored improperly. The device has been stored improperly. The device has been stored improperly.
Markings or labels on the device are illegible. Markings or labels on the device are illegible. Markings or labels on the device are illegible.
It is recommended that a device which shows or which is suspected of faults and It is recommended that a device which shows or which is suspected of faults and
damages is returned i.safe MOBILE GmbH for inspection. damages is returned i.safe MOBILE GmbH for inspection.
EX RELEVANT SAFETY REGULATIONS EX RELEVANT SAFETY REGULATIONS
Use of this device assumes that the operator observes the conventional safety Use of this device assumes that the operator observes the conventional safety
regulations and has read and understood manual, safety instructions and certi cate. regulations and has read and understood manual, safety instructions and certi cate.
The following safety regulations must also be complied with: The following safety regulations must also be complied with:
Inside ex-hazardous areas the covers of the interfaces and the rear cover have Inside ex-hazardous areas the covers of the interfaces and the rear cover have
to be closed. to be closed.
To ensure the IP protection, it has to be ensured that all gaskets are present and To ensure the IP protection, it has to be ensured that all gaskets are present and
functional. There must be no large gap between the two halves of the housing. functional. There must be no large gap between the two halves of the housing.
The battery may only be charged outside ex-hazardous areas. The battery may only be charged outside ex-hazardous areas.
The device may only be charged outside ex-hazardous areas using the appropriate The device may only be charged outside ex-hazardous areas using the appropriate
charger or other equipment approved by i.safe MOBILE GmbH. charger or other equipment approved by i.safe MOBILE GmbH.
The device may be charged only at temperatures in between 5°C ... 35°C. The device may be charged only at temperatures in between 5°C ... 35°C.
The device must not be exposed to abrasive acids or bases. The device must not be exposed to abrasive acids or bases.
The device must not be taken into zones 0, 1, 20 or 21. The device must not be taken into zones 0, 1, 20 or 21.
Only accessories approved by i.safe MOBILE GmbH may be used. Only accessories approved by i.safe MOBILE GmbH may be used.
FURTHER SAFETY ADVISES FURTHER SAFETY ADVISES
Do not touch the screen of the device with sharp objects. Dust particles and nails may Do not touch the screen of the device with sharp objects. Dust particles and nails may Do not touch the screen of the device with sharp objects. Dust particles and nails may
scratch the screen. Please maintain the screen clean. Remove dust on the screen with scratch the screen. Please maintain the screen clean. Remove dust on the screen with scratch the screen. Please maintain the screen clean. Remove dust on the screen with scratch the screen. Please maintain the screen clean. Remove dust on the screen with
a soft cloth gently, and do not scratch the screen. a soft cloth gently, and do not scratch the screen.
Charge the device under indoor conditions only. Charge the device under indoor conditions only. Charge the device under indoor conditions only.
Do not put the device in environments with excessive temperatures, as this could lead Do not put the device in environments with excessive temperatures, as this could lead Do not put the device in environments with excessive temperatures, as this could lead Do not put the device in environments with excessive temperatures, as this could lead
to heating of the battery, resulting in re or explosion. to heating of the battery, resulting in re or explosion.
Do not charge the device near any ammable or explosive substances. Do not charge the device near any ammable or explosive substances. Do not charge the device near any ammable or explosive substances.
Do not charge the device in environments with much dust, humidity, or excessively Do not charge the device in environments with much dust, humidity, or excessively Do not charge the device in environments with much dust, humidity, or excessively Do not charge the device in environments with much dust, humidity, or excessively
high or low temperatures (the permitted charging temperature range is 5 ... 35°C). high or low temperatures (the permitted charging temperature range is 5 ... 35°C). high or low temperatures (the permitted charging temperature range is 5 ... 35°C).
Do not use the device in areas where regulations or legislatives prohibit the use. Do not use the device in areas where regulations or legislatives prohibit the use. Do not use the device in areas where regulations or legislatives prohibit the use. Do not use the device in areas where regulations or legislatives prohibit the use.
Do not expose the device or charger to strong magnetic elds, such as are emitted Do not expose the device or charger to strong magnetic elds, such as are emitted Do not expose the device or charger to strong magnetic elds, such as are emitted Do not expose the device or charger to strong magnetic elds, such as are emitted
from induction ovens or microwaves. from induction ovens or microwaves.
Do not attempt to open or repair the device. Improper repair or opening can lead to Do not attempt to open or repair the device. Improper repair or opening can lead to Do not attempt to open or repair the device. Improper repair or opening can lead to
the destruction of the device, re or explosion. Only authorized personnel are allowed the destruction of the device, re or explosion. Only authorized personnel are allowed the destruction of the device, re or explosion. Only authorized personnel are allowed
to repair the device. to repair the device.
EN EN 5 5