Appliance Description - Beem Multi-back Topclass 3 in 1 Mode D'emploi

EN
■ The mains cable must not pulled
tightly, bent or come into contact with
hot surfaces.
■ Route the cable to prevent risk of trip-
ping.
■ The electrical safety of the appliance
is only assured when it is connected
to a properly installed protective earth
(PE) conductor system. connection to
a mains socket without PE conductor
is forbidden. If in doubt, the electrical
system must be checked by a qualified
electrician. The manufacturer assumes
no liability for injury or damage caused
by a missing or interrupted protective
earth conductor.

Appliance description

(See illustration on the left fold-out page)
1 control panel and display
2 Lid
3 Window
4 Ingredients dispenser
5 Bread baking mould
6 Kneading hook
7 cake baking mould
8 Stirring hook
9 Measuring spoon
10 Measuring cup
11 User manual (not illustrated)
BEEM - Elements of Lifestyle
Multi-back Topclass 3 in 1
Control panel and display (1a/1b)
NOTE
► Press the buttons described below
repeatedly to test all setting options.
An acoustic signal is emitted each
time the button is pressed. Pay
attention to the display; it changes
each time the button is pressed.
► Each combination of programme,
browning level and weight is auto-
matically displayed with the corre-
sponding baking time.
■ : Use this button to select from
the eleven preset programmes. The
set programme appears in the display
under Menu (baking programme 1 -
11).
■ : Use this button to set the weight
of the finished bread. You can choose
between three different sizes:
540g, = 680g or
set weight is underlined in the display.
■ : Use this button to select one of
three different browning levels for pro-
grammes 1 - 4:
dium, = dark. You can also shorten
the baking time in baking programmes
1, 2 or 3 The set browning level is
underlined in the display.
■ : Use this button to start the se-
lected programme. To stop the pro-
gramme, press and hold down this but-
ton for approximately two seconds.
=
= 900g. The
= light, = me-
27