Kerbl SuperHeat Digital Mode D'emploi page 12

Instructions for use - SuperHeat Digital
EN
1. General
This user guide comprises instructions for use and safety information. Please read the instructions carefully and note
the regulations and relevant information before putting the device into operation. Please keep this user guide in a
safe place for later use. You can also find the latest version of this user guide at www.kerbl.com.
2. Correct use
The SuperHeat Digital is intended for warming milk and feed prepared using water. The calf milk heater must not be
used for other purposes, in particular to prevent the freezing of water in feeding troughs and to warm up corrosive
liquids. In the event of incorrect use or modifications to the device, the manufacturer's warranty and liabilities shall
be deemed invalid.
The function of the calf's milk warmer has been optimised for common calf feeding buckets and/or for use in
cylindrical containers with an average diameter of approx. 22 cm and for volumes of liquid of up to 20 litres.
In the event of any deviating conditions, a longer heat-up time may be required and there may be temperature
deviations. The SuperHeat Digital device cannot be used as a temperature measurement device.
3. Safety instructions
CAUTION!
Hot surfaces and defective connection cables.
Risk of burns, electrical shock, fires and short circuits.
Risk of physical injury and material damage if used incorrectly.
• Do not place device on objects or surfaces that are sensitive to heat.
• The surface of the radiator will still be hot when the device is switched off.
Do not touch the radiator or place it on heat-sensitive surfaces.
• Ensure that the container for the liquid to be heated is made from a heat-resistant material.
• Only operate the device in the liquids it is intended for.
• Do not allow access lines to come into contact with hot surfaces, heat, oil or sharp edges.
• Do not pull on the access line to unplug or transport the device. Hang up the access line on the integrated
cable holder (5) when the device is not in use.
• Do not exceed the maximum immersion depth. ('max' position, (9) )
• Do not fall below the minimum immersion depth. ('min' position, (10) )
• Ensure that the device is only used by people who have the professional skills required to do so.
• Ensure that the voltage specified on the type plate matches the voltage of your power source.
• The device may only be connected to mains sockets which are isolated separately via a 30 mA circuit breaker (FI).
• Do not use any multiple sockets. This is a very powerful high performance device.
• Before each use, check that the device and the power cable in particular are in good condition. Do not operate
the device if a component is defective.
• Never operate the device unattended.
• Always keep the device in a safe, dry place out of the reach of children.
• Never remove the device type plate and replace it where necessary.
• National and international safety, health and occupational safety regulations must be observed and complied with.
• The handle section and access line should not come into contact with the liquid being heated.
• This device meets protection class IPX7.
• The device must not be completely submerged.
• When the device is switched on, the liquid to be heated must not be touched.
• Disconnect the device from the power supply before removing from the liquid being heated.
• This device may be used by people with impaired physical, sensory or mental abilities or those with insufficient
experience and knowledge if they are being supervised or have been trained on the safe use of the device and
12