FISCHER DAREX 715004 Mode D'emploi page 63

If there are gas pipes in the building, check to ensure that none of them have
f
been damaged after completing any work on walls, ceilings or floors.
f It is easier to find live cables if electricity consumers (e.g. lights, appliances) are
connected to the cable you are searching for and are switched on. Switch off
electricity consumers and remove the fuse before drilling, sawing or milling
into walls, ceilings or floors. After performing any kind of work, check to
ensure that objects placed on the base material are not live.
When attaching objects to dry walls, and in particular when attaching them
f
to the substructure, check to ensure that both the wall and the fastening
materials have a sufficient load-bearing capacity.
Do not operate the measuring tool in explosive environments, such as in the
f
presence of flammable liquids, gases or dusts. Sparks can be created in the
measuring tool which may ignite the dust or fumes.
f To ensure use of the laser measurer without danger and safely, read all the
instructions carefully and keep them in mind. If the measurer is not used
in compliance with these instructions, the protection devices built into the
measurer are likely to be damaged. Make sure that the warning labels on the
measurer always remain legible.
KEEP THESE INSTRUCTIONS IN A SAFE PLACE AND HAND THEM OVER TO ANY
NEW USER OF THE MEASURER.
Attention – if devices for use or adjustment other than those indicated herein are
used or if other processes are applied, this could lead to dangerous exposure to
radiation.
look into the laser beam. Otherwise you risk dazzling people, causing accidents or
damaging their eyes.
If the laser beam has contact with an eye, close eyes immediately and move head
out of the beam. Never make alterations to the laser device.
Do not use the laser goggles as protective goggles. The laser goggles are used to see
the laser beam better, they do not, however, protect from the laser radiation.
Do not use the laser goggles as sun glasses or when driving. The goggles to see the
laser beam do not completely protect from ultra-violet rays and reduce the perception
of colours.
Only have the measurer repaired by a qualied person and only use original spare
parts. This ensures the safety of the measurer.
Do not let children use the laser measurer unsupervised. They could inadvertently
dazzle other people.
Do not operate the measurers in an explosive atmosphere, for instance near
This measurer is supplied with a warning plate (it is marked
with a number (I) in the representation of the measurer on
the page with the graphics).
Before first-time start-up, cover the text of the warning
plate with the sticker provided in your language.
Do not point the laser beam on people or animals and never
63
EN