Agitator Assembly; Cleaning Agitator; Replacing Agitator - Panasonic QUICKDRAW MC-UG502 Manuel D'utilisation

End Cap
Card
Carte
Tarjeta

Agitator Assembly

Brush
Unit
Belt
Pulley

Cleaning Agitator

➢ ➢ Clean agitator after every five uses
➢ ➢ Remove lower plate.
➢ ➢ Cut off any carpet pile and lint
➢ ➢ Remove agitator.
➢ ➢ Remove any string or debris located
➢ ➢ Reinstall agitator and lower plate.

Replacing Agitator

➢ ➢ When the bristles on the agitator are
➢ ➢ Remove lower plate and agitator.
➢ ➢ Clean debris from end caps.
➢ ➢ Position belt over belt pulley on the
➢ ➢ Reinstall agitator and lower plate.
- 34 -
and every time the belt is replaced.
entangled around agitator with a pair
of scissors.
on the end caps, washers or agitator
shaft.
worn so that they do not touch a card
held across the lower plate, the
agitator should be replaced.
new agitator.
End Cap