Makita PT354D Manuel D'instruction page 7

ASSEMBLY
CAUTION:
Always make sure that your fingers
are not placed on the switch trigger or the contact
element and the battery cartridge is removed
before carrying out any work on the pin nailer.
Loading the pin nailer
CAUTION:
Always make sure that the battery
cartridge is removed before loading the pin nailer.
Unintentional firing may cause personal injuries and
property damage.
CAUTION:
Do not abruptly slide the magazine
of the pin nailer loaded with pin nails. Accidentally
dropping pin nails especially when working in high
places may cause personal injuries.
CAUTION:
Load pin nails in the correct direc-
tion. Loading in wrong direction may cause premature
wear and tear of the driver and damage of the other parts.
CAUTION:
Do not use deformed connected
pin nails. Use pin nails specified in this manual.
Using pin nails other than those specified may cause
pin nail jamming and breakage of the pin nailer.
1. Remove the battery cartridge.
2.
Press the locking lever and slide the magazine
backward.
3. Align the tip of pin nails with the grooves at the
bottom of the magazine and push the whole part of pin
nails toward the driver guide. (Be careful to place pin
nails in the right direction.)
1
4
► 1. Pin nails 2. Magazine 3. Locking lever 4. Driver
guide
4.
place until it clicks.
To remove pin nails, follow the installation procedures
in reverse.
When firing pin nails on the material with easily-marred
surfaces, use the nose adapter. To install the nose
adapter, place it over the driver guide cover so that the
protrusion inside the nose adapter fits to the dent in the
driver guide cover.
You can store the nose adapter on the holder on the
back end of the magazine to keep it from being lost.
► 1. Dent 2. Protrusion 3. Nose adapter 4. Holder
2 3
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
7 ENGLISH
After loading pin nails, push back the magazine in
Nose adapter
CAUTION:
Always make sure that your
fingers are not placed on the switch trigger or
the contact element and the battery cartridge is
removed before installing the nose adapter.
4
3
Hook
CAUTION:
Do not hang the hook from the
waist belt. Dropping the pin nailer, which is caused
by the hook accidentally coming out of place, may
cause unintentional firing and result in personal
injuries.
1
2