Table des Matières
Publicité
FIGURE 4
4A.
BLADESHAFT BEARING SEALS
4B.
FRONT WHEEL BEARINGS
4C.
FRONT AXLE PIVOT BEARINGS
4D.
HYDRAULIC CYLINDER PIVOT PIN
4E.
REAR AXLE
4F.
HYDRAULIC WHEEL MOTOR
4G.
RAISE LOWER CYLINDER
4H.
LINEAR ACTUATOR
52
FIGURE 5
5C
5D
5E
5F
5G 5H
5I 5J
5K
5A.
AIR FILTER ASSEMBLY: Includes
a) Housing
b) Cover
c) Primary Outer Element: Clean or replace when
restriction indicator shows the RED warning.
d) Inner Safety Element: DO NOT CLEAN this
fi lter element. Replace 1 time per year or if it
becomes damaged.
5B.
RADIATOR COOLANT FILL: Fill radiator from this
point. Replace cap if damaged.
5C.
ENGINE OIL FILL: One of two fi ll points.
5D.
FUEL HAND PRIMER PUMP: Push to prime fuel
lines to help initial startup or as needed.
5E.
FUEL BLEED VALVE: Open to bleed air from fuel
lines.
5F.
FUEL FILTER WATER SEPARATOR: See John
Deere engine manual.
5G.
D.C. (direct current) LIFT PUMP: Raises and lowers
the saw.
5H.
HYDRAULIC RESERVOIR FILL: Fill and check
hydraulic system fl uid here.
5I.
HYDRAULIC RESERVOIR: 1.5 Quarts
5J.
HYDRAULIC FILTER: Filters hydraulic system fl uid.
5K.
ENGINE OIL DRAIN HOSE: Connects to oil drain
valve 3I. Use to drain engine oil.
5B
5 A
5O
5N
5L
5M
Publicité
Table des Matières
