Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
How to make the batteries perform longer
(1) Recharge the batteries before they become completely exhausted.
When you feel that the power of the tool becomes weaker, stop using the tool and
recharge its battery. If you continue to use the tool and exhaust the electric current, the
battery may be damaged and its life will become shorter.
(2) Avoid recharging at high temperatures.
A rechargeable battery will be hot immediately after use. If such a battery is recharged
immediately after use, its internal chemical substance will deteriorate, and the battery
life will be shortened. Leave the battery and recharge it after it has cooled for a while.
BEFORE USE
Check the work area to make sure that it is clear of debris and clutter.
Clear the area of unnecessary personnel. Ensure that lighting and ventilation is adequate.
PRIOR TO OPERATION
1. Confirming condition of the environment
Confirm that the work site is placed under appropriate conditions conforming to
prescribed precautions.
2. Attaching the side handle (Fig. 6)
(1) Turn the grip of the side handle to loosen it and
push it in until it comes in contact with the housing.
(2) Adjust the side handle to the angle that allows
the easiest use, then turn the side handle's grip
firmly to lock it place.
3. Mounting the drill bit (Fig. 7)
(1) Clean the shank portion of the drill bit.
(2) Insert the drill bit in a twisting manner into the
tool holder until it latches itself. (Fig. 7)
(3) Check the latching by pulling on the drill bit.
(4) To remove the drill bit, fully pull the grip in the
direction of the arrow and pull out the drill bit.
(Fig. 8)
4. Installation of dust cup or dust collector (B)
(Optional accessories) (Fig. 9, Fig. 10)
When using a rotary hammer for upward drilling
operations attach a dust cup or dust collector (B)
to collect dust or particles for easy operation.
Installing the dust cup
Use the dust cup by attaching to the drill bit a
shown in Fig. 9.
When using a bit which has big diameter, enlarge
the center hole of the dust cup with this rotary
hammer.
Housing
Side
handle
Loosen
Fig. 6
Part of
Drill
Front
SDS-plus
bit
cap
shank
Fig. 7
English
Tighten
Grip
17
Publicité
Table des Matières
