emerio HD-112867.1 Mode D'emploi page 6

HD-112867.1
PARTS DESCRIPTION
1. Air outlet
2. Air inlet
3. Nozzle
4. Filter
5. Cool shot button
6. Heat switch
7. Airflow switch
8. Hanging loop
9. Handle
Heat setting:
= low heat output
= medium heat output
= high heat output
Airflow setting:
" 0 " position = OFF
= Gentle airflow
= Strong airflow
BEFORE USE
1. Fully unwind the mains cable.
2. Attach the nozzle onto the air outlet. Using the hairdressing nozzle, individual sections of the hair can be
dried by bundling the air flow. Make sure that both the nozzle and filter are correctly assembled.
To detach/attach the nozzle
Snap the nozzle off from the air outlet. When you place it back, make sure it is firmly connected.
To detach/attach the filter
Hold and turn the filter anti-clockwise to release it from the appliance. When assembling the filter back, align
the bulge and space at two sides and turn the filter clockwise until the filter is firmly assembled.
HOW TO USE THE HAIRDRYER
1. Make sure the airflow switch is set at the "0" position before you plug the appliance.
2. After connecting the power, select the desired heat and airflow to start drying or styling. Whichever the
setting you choose, as long as you keep pressing the cool shot button, the appliance will send out cool air.
3. Move the hair dryer around your hair and keep your hair in a small distance with the nozzle. Avoid
focusing too much heat on one area. Keep your hair away from the air inlet to prevent hair being drawn in.
4. After use, turn the airflow switch to the "0" position to turn off the appliance, and then remove the plug
from the power outlet.
- 5 -
EN