Programming The Transmitter - Becker Centronic VarioControl VC180 Notice De Montage Et D'utilisation

Assembly and Operating Instructions

Programming the transmitter

1) Ready the VC180 for programming
1. Plug the VC180 into the 230 V mains socket nearest the consumer.
2. The VC180 goes into the programming mode for 3 minutes.
2) Programming the master transmitter
When in the programming mode, press the programming button of the
transmitter until the LED on the VC180 flashes briefly twice to confirm program-
ming.
The programming process has been successfully completed.
Switch on the consumer manually.
3) Programming additional transmitters
Note
In addition to the master transmitter, up to 13 further transmitters can
be programmed in the VC180.
1. Press the programming button of the master transmitter programmed in 2) for
3 seconds.
The LED on the VC180 flashes briefly once to confirm.
2. Now press the programming button of a new transmitter which has not
yet been programmed in the VC180 for 3 seconds. Doing so activates the
programming mode of the VC180 for a new transmitter for 3 minutes.
The LED on the VC180 flashes briefly once to confirm.
3. Now re-press the programming button of the new transmitter you wish to
programme for 3 seconds.
The LED on the VC180 flashes briefly twice to confirm.
The new transmitter has been successfully programmed in.
16