Intended Use - Becker Centronic VarioControl VC180 Notice De Montage Et D'utilisation

Assembly and Operating Instructions
The VC180 may only be used to control a device that is ready to plug in with an
earthed or Euro plug (e.g. lamps, ventilators). The VC180 is connected between
the mains socket and the consumer.
• Please note that radio-controlled systems may not be used in areas with a
high risk of interference (e.g. hospitals, airports).
• The remote control is intended solely for use with equipment and systems in
which malfunctions in the hand-held transmitter or receiver would not pose
any risk to persons, animals or property or which contain safety devices to
eliminate such risks.
• The o perator i s n ot p rotected f rom i nterference f rom o ther t elecommunications
systems and terminal equipment (e.g. even from radio-controlled systems
which are properly operated in the same frequency range).
• Only connect radio receivers to devices and systems approved by the
manufacturer.
Note
Ensure that the control unit is not installed or operated close to metal
surfaces or magnetic fields.
Radio-controlled systems transmitting on the same frequency may
cause reception interference.
Note that the range of the radio signal is limited by legislation as well
as by design.
14

Intended use