Publicité
Les langues disponibles
Les langues disponibles
Am Weingarten 7 • D-30974 Wennigsen • Tel.: +49(0)5103 / 7065-0 • Fax +49(0)5103 / 7065-79
http://www.muss-dental.de • e-mail: muss.dental@t-online.de
O P E R A T I O N
GB
Hints for Safe Disposal of Product
Instruction according "Waste Electrical and Electronic Equipment" WEEE-guide line 2002/96/EG. Please do not dispose
the device in your household waste,
Questions and Answers
- The speed can not be adjusted at the control unit: Change or adjust the electronics or the potentiometer
(service engineer).
- The chuck does not hold the burs anymore or bad whirling arm: The chuck is dirty or broken (look
at the maintenance instruction); check or replace it.
- The handpiece makes strange noises: The bur was not inserted correctly, or turn the handpiece sleeve to the end
point or replace ball bearings (service engineer).
- Error shown in display:
If other problems occur which are not listed under "Questions and Answers" please call the
manufacturer: +49 5103 70650
Manufacturer:
Muss Dental GmbH
Am Weingarten 7
D-30974 Wennigsen
GERMANY
Tel.: +49 5103 70650
Fax: +49 5103 706579
e-mail: muss.dental@t-online.de
Internet: www.muss-dental.de
Explanations of the Symbols on the Product:
Motor hub
Hub for treadle switch
Clockwise/counter-clockwise rotation
or
Explanations of the Symbols Mentioned in the Operation Instructions:
Generic warning
Cutting hazard warning
Arc flash (danger electricity)
Eye protection must be worn
General mandatory sign
Information
but deliver it to a special place
E1
Overcurrent
Motor shorted
-
Motor cable broken
-
Motor cable not connected
-
Motor cable in control unit broken
-
E2
Start-up commutation error
Overload protection was activated
-
Start-up failure
-
E3
Motor uses more than 42,5 V
E4
Low voltage in mains
E5
Temperature above 70°C (data is measured on the circuit board).
I N S T R U C T I O N S
Technical data may change 12/05
Seite 13 von 20
Publicité
