Publicité
Les langues disponibles
Les langues disponibles
Am Weingarten 7 • D-30974 Wennigsen • Tel.: +49(0)5103 / 7065-0 • Fax +49(0)5103 / 7065-79
http://www.muss-dental.de • e-mail: muss.dental@t-online.de
O P E R A T I O N
GB
Accident Prevention Regulations are to be followed!
If the handpiece is not in use, it should be placed on the handpiece holder, or on any other proper holder.
If the unit is not in proper condition or is not being handled correctly, it is possible that injuries may occur
or cause damage to the material and unit.
Unplug the unit before opening the housing
The repair and maintenance of the electrical parts of the unit may only be done by professionally skilled
and trained workers, informed of the safety guidelines. New spare parts, used in repairing the unit must
be in accordance with spare-parts with the manufacturer required specifications.
Scope of Delivery/Dimensions: F351 / H350
Operating unit, power cord, handpiece, handpiece holder, chuck key, box spanner, cleaning brush, operation
instructions, certificate of warranty.
Measurement control unit:
Measurement handpiece:
Scope of Delivery/Dimensions: K351 / H350
Operating unit, power cord, handpiece , handpiece holder, chuck key, box spanner, cleaning brush, drill template,
hanging, 2 screws, operation instructions, certificate of warranty.
Measurement control unit:
Measurement handpiece:
Scope of Delivery/Dimensions: T351 / H350
Operating unit, power cord, handpiece , treadle switch, handpiece holder, chuck key, box spanner, cleaning brush,
operation instructions, certificate of warranty.
Measurement control unit:
Measurement handpiece:
Startup (according to the scope of delivery)
- Remove the device completely out of the packaging.
- Set up the table top control unit at an adequate workstation.
- Set up the foot control unit at an adequate workstation.
- Mount the knee control unit onto your table/bench according to the separate instructions (written on the drill template
MU 3061).
Cable Connections
The handpiece needs to be connected and blocked at the back of the control unit at the hub
Insert the power cord into the back of the control unit and afterwards the plug needs to be plugged into the power
socket.
Only for table top control units: The treadle switch needs to be connected and blocked at the back of the control
unit at the hub
.
Operation of Handpiece: H350
Chance the burs only when the handpiece has come to a complete stop. No warranty by disregard! To open the
mechanism (for chuck) you need to turn the grip sleeve clockwise in order to exchange the desired burs. In order to
close it again, you need to turn the grip sleeve counter clockwise until it snaps.
Operation of Foot Control Unit: F351
The rate of revolutions will be continuously variable by activating the foot lever into the direction of max. speed. The
handpiece stops by releasing the foot lever.
W 23 cm x D 26 cm x H 15 cm, weight: 3,1 kg
L 17 cm, ø 3 cm, weight: 280 g
W 33 cm x D 23 cm x H 10 cm, weight: 3,5 kg
L 17 cm, ø 3 cm, weight: 280 g
W 33 cm x D 23 cm x H 9 cm, weight: 3,5 kg
L 17 cm, ø 3 cm, weight: 280 g
I N S T R U C T I O N
.
Seite 10 von 20
Publicité
