If the switch setting and the cable connected to the con-
nector do not match, audio input will not be possible.
G
USB CHARGE switch
When set to OFF, charging will not occur through the
PC connector.
Set this to ON to charge through the PC connector.
Even when this is set to ON, if a power supply is con-
nected to the DC IN 5V connector, power will be
supplied through it instead. In this case, charging will not
occur from the PC connector.
H
I
H
Status indicators
When the unit is turned on, the number of LEDs lit show
the remaining battery charge.
The lit indicator shows the D/A conversion mode used
by the unit. (Nothing lights during analog audio input.)
I
CHARGE indicator
This lights when the unit is charging and becomes unlit
when charging completes.
J
Force shutdown switch
Turn the power/volume knob to the OFF position, and
then insert a fine pin such as the end of a paper clip
into this hole.
The unit turns off.
K
PC connector
Use the included USB cable for computer connection
(USB micro-B connector to USB A connector) to connect
this unit to a computer. You can also use a commercial-
ly-available OTG cable to connect an Android device.
Operation is not guaranteed, however, with all Android
devices.
L
iPod/iPhone/iPad connector
Use the USB cable included with the iPod/iPhone/iPad
device to connect it to this unit.
o Connecting anything other than an iPod/iPhone/iPad
to this port could cause the operation time of the
battery to be significantly reduced.
M
DC IN 5V connector
Using the included DC power supply cable, connect a
commercially-available USB AC adapter. Use a USB AC
adapter that has an output current of at least 1.0 A.
K
J
Connect one
or the other.
OTG cable
(Commercial product)
N
LINE OUT connector
This outputs analog audio. Using a commercially-avail-
able cable with a 3.5mm stereo mini plug, connect this
to speakers with built-in amplifiers, a stereo amplifier or
other device.
L
M
N
USB cable included with
iPod/iPhone/iPad device
Speakers with built-in amplifiers,
stereo amplifier, etc.
7