LUMENE ShowPlace HD Mode D'emploi page 21

LOWER & UPPER STOPS SETTINGS (EXTRADROP)
EXTRADROP
PROJECTION AREA
FOR SCREEN SETTINGS, WE CONSIDER THAT WE LOOK AT THE CASE FROM BELOW (IMPORTANT FOR CLOCKWISE AND
COUNTER-CLOCKWISE SETTINGS).
1
Locate the adjusting screws on the screen : on the left side of the case is an opening revealing two screws.
2
Briefly trigger the opening of the screen, in order to roll down the screen for a few inches. Using the
provided adjustment key, adjust the stops. (continued on next page)
The extradrop is the black zone of a Lumene screen located above the projection
area. The height of this black zone can be adjusted so you can position the
projection area vertically.
ATTENTION :
• By default, the stops of the screen are perfectly adjusted. We do not recommend any adjustment
in order to prevent potential damages on the product. Please contact our customer service for any
further information.
• Any damage resulting from an improper adjustment carried out by the user will be excluded from
the warranty of this product.
• However, if you need to set the upper and lower stops of your screen again, follow the instructions
below. Please be sure to make these adjustments with the utmost care.
21
Green screw
Yellow screw
UK