LUMENE ShowPlace HD Mode D'emploi page 19

CONTROL METHODS
1
IR remote control / RF remote control (optional)
Daily use
• Press « up » to retract the screen
• Press « stop » to stop the screen
• Press « down » to lower the screen
Pairing :
• Connect the screen to power.
• « Pairing » mode is activated for 10 seconds.
• During this time, press « up » and « stop » simultaneously.
• Pairing is successful when the screen goes down and up for a few inches.
Un-pairing :
• Unplug and reconnect the screen to power.
• « Pairing » mode is activated for 10 seconds.
• During this time, press « up » and « stop » simultaneously to clear memory.
• Pairing is removed.
LED
Up
Stop
Down
IR remote control
Up
Stop
Down
RF remote control
(optional)
• « Pairing » mode will be activated when connecting the screen to power. To activate « pairing » mode
if your screen is already installed, you need to unplug and reconnect the screen.
• If pairing failed, or if you want to pair the remote control again, you need to unplug and reconnect
the screen to activate « pairing » mode.
• Handling must be done within 10 seconds after connecting to power.
RS485/RS232 interface
and dry control
Manual control
IR interface
19
IR/RF sensor
Range :
IR remote control :
up to 12m, ± 60°
RF remote control :
up to 20m
Effective range
up to 60°
UK