What To Do If - IKEA FRAMTID OV9 Mode D'emploi

ENGLISH
1
Pull the rails away
from the oven wall at
the front.
To put the side rails back, follow the instruction
in reverse.
Important! The rounded ends of the guide
bars must point to the front.
Changing the oven lamp and cleaning the
glass cover
Warning! Before you change the oven
lamp (refer to "Product description"),

What to do if...

Problem
The oven does not op-
erate
The oven does not op-
erate
The temperature indica-
tor does not come on
The oven lamp is not
working
There is water inside the
oven
The steam cooking does
not work
Steam and condensa-
tion settle on the food
and in the oven cavity
2
2
1
Then unhook the rails
at the back.
Possible cause
The required setting have not
been set
The appliance is not correctly
connected or/and the mains
supply to the oven is not on
The required setting have not
been set
The oven lamp bulb is faulty
There is too much water in the
tank
Lime obstructs the hole
Dishes have been left in the oven
for too long
switch off the appliance and disconnect it from
the electrical supply.
1. Turn the glass cover anti - clockwise and
remove it. Clean the glass cover.
2. If necessary, replace the old oven lamp
with a 15/25 watt, 230V (50Hz), 300 °C
heat resistant oven lamp (Connection type:
E14).
3. Refit the glass cover.
check if cooking function and tem-
perature are selected
Check if the appliance is correctly
connected and the mains supply
to the oven is on
Select the cooking function and
temperature
Replace the oven lamp bulb
Turn the oven off and wipe the
water with a cloth or sponge
Check the steam inlet opening.
Remove the lime
Do not leave the dishes standing
in the oven for longer than 15-20
minutes after the cooking process
ends
14
Solution