Burg Wächter TRSE 6000 Manuel D'utilisation page 11

5. Storing a user with fingerprint*
– Press the On / Enter key
– The indication of Code / Fingerp is displayed
– Press the Function key
– The Change code menu is displayed
– By pressing the key 2 reach the Administrator menu
– Press the On / Enter key
– Admin setup Create user is displayed
– Press the On / Enter key
– By pressing the key 2 several times reach the Create fingerscan menu
– Press the Function key
– At this point you are asked to enter the admin.
Code (factory setting 123456)
– The indication of Create fingerscan is displayed
– The indication of Store finger is displayed
– Please pull your finger over the sensor for several times according
to the instructions shown on the display
– After a successful entry the indication User xxx successfully created
is displayed
Attention: When saving a fingerprint it is important that the finger is laid
evenly and in a straight position over the sensor. Follow the instructions
on the display. The finger is saved only when it can be read in an optimum
quality.
TSE BUSINESS 5000
6. Opening with fingerprint*
– Press the On / Enter key
– The indication of Code / Fingerp is displayed
– Move the saved finger over the sensor
– Value not achieved is displayed for a short time
– The Code / Fingerp indication is displayed
– At this point, enter an additional opening code.
– The instruction Please turn knob is displayed
7. Deleting a finger*
– Press the On / Enter key
– The indication of Code / Fingerp is displayed
– Press the Function key
– The Change code menu is displayed
– By pressing the key 2 reach the Administrator menu
– Press the On / Enter key
– Admin setup Create user is displayed
– By pressing the key 2 reach the Admin. setup Delete menu
– Press the On / Enter key
– Delete user is displayed
– Press the On / Enter key
– At this point you are asked to enter the admin.
Code (factory setting 123456)
– Now you have to select the appropriate user by pressing the keys 1 or 2
– Press the On / Enter key
– The indication of Delete data to be confirmed with the On key
is displayed.
– Press the On / Enter key
– The indication of Data record deleted is displayed
Additional users can be deleted using the On / Enter key. By pressing the
Function key, you can reach higher menu levels up to the code entry.
2.5 Error messages*
The following error messages are indicated when a finger is being
saved or the safe opened:
Error message Elimination of causes
too fast! Move the finger more slowly over the sensor
please repeat
too aslant! Move the finger straight over the sensor
please repeat
too short! Move the finger over the sensor in a way allowing
please repeat more surface area to be rea
place to the center Place your finger centrally over the sensor
and repeat!
English | 11