Berner BACR 12 V Notice Originale page 16

OBJ_BUCH-2335-002.book Page 16 Friday, September 8, 2017 9:51 AM
Setting the Time
– To set the time, press the
hours indication flashes in display element e.
– Press the seek button 12 or the
ton 11 until the correct hour setting is indicated.
– Press the button 10 again, so that the minutes
indication flashes in display element e.
– Press the seek button 12 or the
ton 11 until the correct minute setting is indi-
cated.
– Press the button 10 a third time to store the
time setting.
Working Advice
Recommendations for Optimal Handling of the
Battery
Protect the battery against moisture and water.
Store the battery only within a temperature range
between –20 °C and 50 °C. As an example, do
not leave the battery in the car in summer.
A battery that is new or has not been used for a
longer period does not develop its full capacity un-
til after approx. 5 charging/discharging cycles.
A significantly reduced working period after charg-
ing indicates that the battery is used and must be
replaced.
Observe the notes for disposal.
Troubleshooting – Causes and
Corrective Measures
Cause Corrective Measure
Construction site radio inoperative
No power supply Completely insert the
power-supply plug and
plug-in connector or the
charged battery pack
Construction site radio Wait until the construc-
too warm or too cold tion site radio has
reached operating tem-
perature
Construction site radio inoperative on AC
power supply
Power-supply plug or Check the power-supply
connection cable plug and the connection
defective cable, and have them
replaced as required
Wrong power-supply Use the original Berner
plug inserted power-supply plug (also
available as spare part)
16 | English
Cause
button 10 until the
Construction site radio inoperative on DC
power supply
seek but-
Battery contacts con-
taminated
seek but-
Battery pack defective Replace the battery
Battery pack too warm
or too cold
Construction site radio suddenly inoperative
Power-supply plug or
battery pack not prop-
erly or completely
inserted
Bad radio reception
Interference from other
devices or insufficient
set-up location
Time indication faulty
Back-up batteries of
clock empty
Back-up batteries
incorrectly inserted
(wrong polarity)
When the corrective measures do not eliminate an
error, please contact an authorised service agent
for Berner power tools.
Maintenance and Service
Maintenance and Cleaning
For safe and proper working, always keep the con-
struction site radio clean.
Wipe off debris using a moist and soft cloth. Do not
use any cleaning agents or solvents.
In all correspondence and spare parts orders,
please always include the 6-digit article number
given on the type plate of the construction site radio.
Corrective Measure
Clean the battery con-
tacts (e.g. by inserting
and removing the battery
several times) or replace
the battery
Wait until the battery has
reached operating tem-
perature
Plug in power-supply
plug or battery properly
and completely
Position the construction
site radio at another
location with better
reception or with greater
clearance to other elec-
tronic devices
Replace back-up batter-
ies
Insert back-up batteries
correctly
1 609 92A 43Z • 8.9.17